Port Configuration - Interlogix GE-DS-242-PoE User Manual

Port Configuration

In Port control you can configure the settings of each port to control the
connection parameters, the status of each port is listed below.
Figure 4-19: Port Control interface
This page includes the following fields:
OBJECT
Port
State
Negotiation
Speed
Duplex
Flow Control
GE-DS-242-PoE Managed Ethernet Switch User Manual
DESCRIPTION
Use the scroll bar and click on the port number to choose the port to
be configured.
Current port state. The port can be set to disable or enable mode. If
the port state is set as 'Disable', it will not receive or transmit any
packet.
Auto and Force. Being set as Auto, the speed and duplex mode are
negotiated automatically. When you set it as Force, you have to set
the speed and duplex mode manually.
It is available for selecting when the Negotiation column is set as
Force. When the Negotiation column is set as Auto, this column is
read-only.
It is available for selecting when the Negotiation column is set as
Force. When the Negotiation column is set as Auto, this column is
read-only.
Whether or not the receiving node sends feedback to the sending
node is determined by this item. When enabled, once the device
exceeds the input data rate of another device, the receiving device
will send a PAUSE frame which halts the transmission of the sender
for a specified period of time. When disabled, the receiving device
will drop the packet if too much to process.
Chapter 4: Console Management
49