Command Line Interface; Accessing The Cli - Interlogix IFS NS3601-24P User Manual

COMMAND LINE INTERFACE

Accessing the CLI

When accessing the management interface for the switch over a direct connection to the server's console port, or via a Telnet
connection, the switch can be managed by entering command keywords and parameters at the prompt. Using the switch's
command-line interface (CLI) is very similar to entering commands on a UNIX system.
This chapter describes how to use the Command Line Interface (CLI).
Logon to the Console
Once the terminal has connected to the device, power on the IFS Managed Switch, the terminal will display that it is running testing
procedures.
Then, the following message asks the login username & password. The factory default password as following and the login screen is
shown Figure 5-1.
Username: admin
Password: admin
1. For security reason, please change and memorize the new password after this first setup.
2. Only accept command in lowercase letter under console interface.
IFS NS3601-24P/4S GE-DSSG-244 and 244-POE User Manual
Figure 5-1 IFS Managed Switch Console Login screen
263