Table of Contents
Advertisement
Forcing a Call to be Answered
Below is a sample short code that forces a call to be automatically answered.
Short Code: *83*N#
Telephone Number: N
Feature: DialDirect
N represents the extension that will be forced to automatically answer. For example, when a
user dials *83*201#, extension 201 will be forced to automatically answer the call.
Pick up a Ringing Phone
The sample short code below is a default within the Manager configuration. This shortcode
enables the user to pickup any ringing phone. Below is the setup for the shortcode.
Short Code: *6
Telephone Number: leave blank
Line Group ID: 0
Feature: CallPickupAny
Create a PSTN Backup Route
The sample short code below creates a PSTN backup route to extensions at the other
Communication Manager sites. For example, if the extensions (64xxx) at the Communication
Manager sites have DDI/DID of 1408 555 2xxx, then the following short code should be set up:
Short Code: 64xxx
Telephone Number: 14085552xxx
Line Group ID: 0
Feature: Dial
Modem Control Shortcode
The default shortcode, *4000*, controls the on/off functionality of the internal modem attached
to the first analog trunk (if the modem is enabled via Manager). To set up remote access, see
Remote
Access.
Note:
If the system switches from suvivable to sub-tending mode while the modem is
Note:
switched On, it will remain On until G150 goes into survivable mode again or it is
restarted, because short codes are only processed during survivable mode.
Using Shortcodes
Issue 1 June 2005
151
Advertisement
Table of Contents
