Table of Contents
Advertisement
Define what capabilities this operator will have for creating additional operator accounts
by setting the following:
- View: This allows the operator to view existing Operator entries.
- Edit: This allows the operator to make changes to existing Operator entries.
- New: This allows the operator to create new Operator accounts.
- Delete: This allows the operator to delete existing Operator entries.
5. The other tabs represent access rights to the other configuration forms. Use the check
boxes to select what access this operator will have to which parts of each configuration
form.
6. The Operator settings are not part of the IP Office control unit configuration; thus, it is not
necessary to send the changes to the control unit or reboot it. Operator settings are stored
on the Manager PC in .ops files in the Manager directory.
7. After all the necessary configuration access rights have been defined, click OK. The new
operator has been created.
Specify an IP Address to the G150
By default, the broadcast address (255.255.255.255) is used and all G150s on the local LAN
are then displayed when
addresses (maximum 10) allows quicker selection of the G150 required and is mandatory when
managing a remote G150. The constraint of 10 IP addresses maximum is because each install
of a Manager application can remember the IP addresses of only 10 G150 systems at any one
time. If the PC has two LAN connections, then it is necessary to set the IP address to the
broadcast address of the LAN, eg. 192.168.42.255.
Before specifying an IP address to the G150, an entry for this IP address must be created.
To create an IP address entry and then specify it for use:
1. Open Manager and log on.
2. From the Preferences menu, select Edit. This command allows you to specify the IP
address of the G150 you wish to manage. It opens an edit window similar to
is clicked to request for a configuration. Specifying individual
The Manager Application Software
Figure
Issue 1 June 2005
43.
95
Advertisement
Table of Contents
