Table of Contents
Advertisement
Configuring the G150 Media Gateway with Manager
Trunk Configuration
Incoming Trunk Call with No DID (DDI) Information
When an incoming trunk call is received by the G150 with no DDI information, a default
Communication Manager extension number is dialed. The default extension number is 1001.
This default extension number for all trunks can be configured by doing the following:
1. Click
displaying the IP address of the G150. Enter the G150 system password.
2. Click System from the Configuration Tree and double click the G150 configuration on the
right hand side of the display window.
3. Click the SO Gateway tab. In the Destination When No DDI field, enter the
Communication Manager extension number you want dialed. The number can contain up to
9 digits, including * (asterisk) or # (pound/hash). The field must contain at least one digit.
Note:
This Destination When No DDI number may be overridden for each analog
Note:
trunk. See
4. Click OK.
5. If this is the last configuration being performed on Manager, click
Config To dialog box, accept the selected save option and click OK. Otherwise, continue
making additional configuration updates and perform a Save when ready.
Configure Trunk Queuing
When an incoming PRI or BRI trunk call is received and no VoIP/VCM resources are available,
G150 can be configured to respond accordingly. The two configuration options are:
Calls remain in the queue (and ringing is heard) pending a free VoIP/VCM resource.
Callers are not held in the queue and a busy tone is heard.
Note:
Calls coming in through an Analog or T1 trunk will always receive ringing tone
Note:
until a VoIP/VCM resource are free, regardless of the setting on the Queue
Trunk When Unavailable field.
104 Installation and Configuration of the G150 Media Gateway
to receive a configuration form. The Receiving Config from dialog box appears
Analog Trunk Configuration
on page 106.
Save. In the Sending
Advertisement
Table of Contents
