Table of Contents
Advertisement
Upgrading the G150 Media Gateway
Upgrading G150 Core Software
To upgrade the G150 core software:
1. Ensure that you have followed the
2. Ensure that you have received and made a copy of the G150 configuration. If the upgrade
fails, the current configuration may be erased so a backup copy is an essential precaution.
3. In Manager, select File | Advanced | Upgrade. This starts the UpgradeWiz application.
Figure 95: Manager Upgrade Wizard
4. The wizard lists the G150s it has found on the LAN. Tick the G150 system being upgraded.
Based on
No Units Listed
If this message is displayed with the G150 using the Broadcast Address of
255.255.255.255, it implies that the Manager PC is not connected to any local G150.
At this point, you should enter the specific IP address of the G150 you wish to upgrade
(by clicking the drop down box associated with the Unit/Broadcast Address field or
entering the IP address into this field and click Refresh) or check the network settings.
The list also shows the current software level of the units (under the Version column) and
the level of the appropriate/new bin file that Manager has available (under the Available
column) for each unit.
5. With a new bin file available for upgrading (displayed under the Available column), the tick
the box for those G150s that you want to upgrade should be ticked by default.
6. Leave the Validate box ticked. With the Validate box ticked, the system will check that it
has received the new .bin files before erasing the old version and give the option to
upgrade. If the Validate box is not ticked, a validated upgrade will not be performed. The
validated upgrade function can be performed on both a remote and local upgrade.
214 Installation and Configuration of the G150 Media Gateway
Figure
95, tick the SOG6_SV.
Pre-Upgrade Checks
on page 211.
Advertisement
Table of Contents
