BHT-904BB
1.1 System Configuration
This section describes the hardware required for the barcode data collection system used by the BHT and the BHT
software.
1.1.1
Hardware Configuration
In addition to the BHT, the following hardware and software are required for the barcode data collection
system used by the BHT.
Please note that certain components of the required hardware will differ depending on the type of
communication used.
• Host computer(Option)
• CU-900 Series (Option): Communication unit
• Connection cable (Option): Used to connect the BHT or CU-900 Series and host computer.
• Bluetooth
®
compatible device (Option)
• Software: BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC 4.0 Transfer Utility (Option)
®
Bluetooth
-enabled printers
(Option)
●: Required for system configuration
(1) IrDA communication
(2) Bluetooth® wireless
communication
(3) USB Communication
*1 When the host computer is equipped with the Bluetooth
*2 The BHT supports the following profiles.
・ Generic Access Profile
・ Serial Port Profile
・ Dialup Networking Profile
2
®
(2) Bluetooth
wireless
communication
(1) IrDA communication
CU (Option)
Host computer
BHT
●
●
●*1
●*2
●
-
BHT
®
(2) Bluetooth
wireless
communication
(3) USB Communication
Connection cable
(Option)
Connection cable (Option)
BHT-BASIC 4.0 Development Pack (Option)
BHT-BASIC 4.0 Transfer Utility (Option)
®
Bluetooth
CU
compatible device
●
-
●
-
-
-
®
wireless communication device.
Host computer (Option)
Software
Ref. Page
●
Page 30
●
Page 31
Page 32
●