Denso BHT-904BB User Manual page 119

Setting the Barcode reading Test Options
Press F1 key at the TEST BARCODE screen to set the barcode reading
test options. The screen displays as shown on the right.
The highlighted settings will be the current settings.
To change the setting, use the cursor keys ([◄] [►]) to highlight the
desired setting.
Press the F1, ENT, or Backspace/clear key to return to the TEST BARCODE screen.
"1: READ SETTING":
Sets the read conditions of the barcode reading test.
"DEFAULT":
"SYSTEM PARAMETER":
Barcodes allowed to be read in the "DEFAULT" setting
EAN-13 (JAN-13), UPC-A
*1
EAN-8 (JAN-8)
*1
UPC-E
Interleaved 2of5 (ITF)
Codabar (NW-7)
Code 39
Code 93
Code 128, GS1-128 (EAN-128)
RSS (GS1 DataBar)
Standard 2of5 (STF)
*1
Excludes those with add-on.
*2
With ITF, a barcode with 4 or more digits is read.
*3
With STF, a barcode with 3 or more digits is read.
To read the EAN/UPC barcode with add-on in the barcode reading test, it is necessary to
− Point −
set the system setting and then set to "SYSTEM PARAMETER".
Reads barcodes according to the default read condition.
Sets the read condition via the system setting. It allows the read
condition to be set more precisely.
When carrying out the system setting, refer to the setting for the
"function in which the read setting is specified from the system
settings" in "4.5.6 [4] Setting the special barcode reading
parameters".
*1
*2
*3
Barcode Handy Terminal
103