Denso BHT-904BB User Manual page 153

5.
Use the cursor keys ([▲] [▼]) or numeric key ([3]) to highlight [3: NUM RESPONSES] and then
press the ENT key.
Entry mode is activated and the cursor is displayed.
6.
Use the numeric keys to enter the desired setting.
Set the number of detected devices temporarily used to carry out device inquiry via [1: DO IT].
The setting range is 0 to 8. If "0" is set, a maximum of 8 devices is detected. 0 is initially set. Note that the
setting specified here is not saved.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold the
Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
7.
Press the ENT key.
8.
Use the cursor keys ([▲] [▼]) or numeric key ([1]) to highlight
[1: DO IT] and then press the ENT key.
The screen on the right appears and the device inquiry starts.
In the cases below, the device inquiry ends and the screen on the right
appears.
● The specified number of devices have been found.
● The specified time has elapsed.
● The user has pressed the Backspace/clear key on the Working screen.
Press the Backspace/clear key to return to the BROWSE DEVICE menu.
If the detected device is set as the address of the destination remote device during master connection,
use the cursor keys ([▲] [▼]) or numeric keys to select the desired address and then press the ENT key.
Barcode Handy Terminal
137