Denso BHT-904BB User Manual page 149

Setting the serial port profile (SPP) service for connection target
1.
Press numeric key [7] with the SF key pressed at the SET
MASTER screen to display the screen on the right.
[1: SPP SERVICE]:
Press the Backspace/clear key to return to the SET MASTER screen.
2.
Press the ENT key.
Entry mode is activated and the cursor is displayed.
3.
Use the numeric and period (.) keys to enter a service name of the serial port to be connected.
A maximum of 12-characters can be entered. There is no default setting.
To toggle the entry mode (between numeric and alphabet entries), press the SF key.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold the
Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
4.
Press the ENT key.
5.
Press the Backspace/clear key.
The SET MASTER screen reappears.
If the target remote device has two or more serial port services, the link is established with
− Point −
any of them. Specifying the serial port service name on the above screen selects the
specified one. For the service name of the destination remote device, refer to "[3] BROWSE
DEVICE menu" – "Searching for services".
Specifies the serial port service name for the
connection target.
Barcode Handy Terminal
133