Denso BHT-904BB User Manual page 104

BHT-904BB
"5: OPEN "COM:" DETAIL": OPEN "COM:" communication condition setting
For the communication condition setting for the user program (OPEN "COM:") created via BHT-BASIC,
the system mode setting can be used. Therefore, it is not necessary to specify the communication
condition setting. Even if the transmission speed must be changed, the user program does not need to be
changed.
1.
Select "5: OPEN "COM:" DETAIL" at the SET COMMUNICATION menu and then press the
ENT key.
The OPEN "COM" DETAIL screen appears.
The highlighted setting is the current setting.
"1: SETTINGS FROM"
Sets the communication condition setting for the user program (OPEN
"COM:") created via BHT-BASIC to either the setting specified in the
user program or via the system mode setting.
"API":
Uses the setting specified in the user program (default).
"SYSTEM":
Uses the system mode setting (setting specified in the user program is not used).
Communication condition
Interface in use *1
Transmission speed
Serial communication
protocol
*1: Regardless of the interface specified in the user program, the operation is carried out using the
interface specified in the system mode. e.g., even if OPEN "COM:2" is specified; if COM1 is specified
in the system mode, the operation is carried out using COM1. Note, however, if COM3 or COM4 is
specified, the operation is carried out according to the setting specified in the user program.
88
System mode setting screen
("SET COMMUNICATION" menu)
"3:COM PORT"
↓
"1:BASIC"
"1:OPTICAL"
↓
"1:PARAMETER"
↓
"1:TRANSMIT SPEED"
"2:PROTOCOL TYPE"
Target API
OPEN "COM:"
Out .pnCmPrtcl (6060)