Denso BHT-904BB User Manual page 112

BHT-904BB
Setting the DHCP
1.
Select "3: DHCP" at the SET TCP/IP menu and then press the
ENT key.
The SET DHCP screen displays as shown on the right. The highlighted
setting will be the current setting.
Press the Backspace/clear key to return to the SET TCP/IP menu.
Press the dot key while holding down the SF key at the SET DHCP menu
to display the NETWORK (DHCP) screen (acquisition check screen for
IP address at DHCP).
Press the Backspace/clear key at the NETWORK (DHCP) screen to
return to the SET DHCP screen.
If the acquired IP configuration is displayed when the IP
− Point −
address, subnet mask or default gateway is set to a value
other than "0.0.0.0", the DHCP does not display on the
screen shown on the right.
"1: TIMEOUT":
Sets the timeout for acquiring the IP configuration from the DHCP server.
The entry range is from 00001 to 32767 seconds.
Up to 32767 seconds can be entered, but in actual operation, a maximum of 190 seconds is
− Point −
available since the number of retries and retry intervals are determined by the system.
To set the DHCP:
(1) Press the ENT key.
(2) The mode changes to entry mode and the cursor displays, allowing the setting to be entered with the
numeric keys.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold
the Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
(3) Enter the desired value, and then press the ENT key.
Press the Backspace/clear key to return to the SET FTP menu.
96
BS/C key ⇑ ⇓ SF + [.] key