System Configuration; Hardware Configuration - Denso BHT-904B User Manual

BHT-904B/BHT-914B

1.1 System Configuration

This section describes the hardware required for the barcode data collection system used by the BHT and the BHT
software.
1.1.1

Hardware Configuration

In addition to the BHT, the following hardware and software are required for the barcode data collection
system used by the BHT.
Please note that certain components of the required hardware will differ depending on the type of
communication used.
 Host computer(Option)
 CU-900 Series (Option): Communication unit
 Connection cable (Option): Used to connect the BHT or CU-900 Series and host computer.
 Software: BHT-BASIC 4.0 Development Pack (Option) and BHT-BASIC 4.0 Transfer Utility (Option)
(1) IrDA communication
●: Required for system configuration
(1) IrDA communication
(2) USB Communication
2
BHT
(2) USB Communication
CU (Option)
Host computer BHT
● ●
● －
Host computer (Option)
Connection cable
(Option)
Connection cable (Option)
BHT-BASIC 4.0 Development Pack (Option)
BHT-BASIC 4.0 Transfer Utility (Option)
CU
●
－
Software Ref. Page
● Page 30
Page 31
●