Table of Contents
Advertisement
CDM-700 High Speed Satellite Modem
Front Panel Operation
Comp Tx Data/Sym Rate:
034.36800/23.484800
This display shows the Composite Tx Data Rate (Mbps) that is the sum of all enabled terrestrial
ports. The Symbol Rate (Msps) is the IF Symbol Rate based on the Composite Data Rate,
Overhead, Modulation, and Coding.
Press
or
ENTER
If Intfc1 Port1 Tx:
Intfc1 Port1 Status
Enable Disable
This selection activates or deactivates the transmit (Tx) side of Port1. Disabling the Tx port
deactivates the port and changes the data rate to 0.
Select Enable or Disable using the
If Intfc1 Port1 E3/T3/STS1:
Intfc1 Port 1 Rx: Alarms
Buf Clk Ena/Dis (
Select Alarms, Inv, Data, Buf, Clk or Ena/Dis using the
If Intfc1 Port1 Rx:
Intfc1 Port1 Rx Alarms:
Rx-AIS
Select Rx-AIS or Buffer-Slip, using the
Fault condition. Press
If Intfc1 Port1 Rx Alarms:
Rx-AIS Alarm:
Alarm
This selection will affect the event reporting status upon detection of a Rx AIS condition, and
subsequently the switching logic, when the modem is in a 1:1 redundancy configuration.
Select Alarm, Fault, or Mask using the
If Intfc1 Port1 Rx Alarms:
to return to the previous menu.
CLEAR
Ena/Dis is selected:
◄ ►
Rx is selected:
Alarms is selected:
Buffer-Slip
.
ENTER
Rx-AIS is selected:
Fault
Mask
Buffer-Slip is selected:
(E)
(
E)
arrow keys. Press
ENTER
Inv Data
E)
◄ ►
(
E)
◄ ►
arrow keys, to configure either as an Alarm or
(
E)
◄ ►
arrow keys. Press
6–26
MN/CDM700.IOM
.
arrow keys. Press
ENTER
.
ENTER
Revision 5
.
Advertisement
Table of Contents
