Intfc1 Gigabit Ethernet: Tx - Comtech EF Data CDM-700 Installation And Operation Manual

CDM-700 High Speed Satellite Modem
Front Panel Operation
Intfc1 Gigabit Ethernet:
Intfc1 Tx:
Data
Select Data, Enable, or Alarm using the
If Intfc1 Tx:
Intfc1 Data Rate:
Tx:075.000000 Mbps
Intfc1 Data Rate:
Tx: Disabled
Edit the Tx Data Rate by selecting the digit to be edited, using the
of the digit is then changed using the
Mbps.
Note that the modem Symbol Rate limits of 1.0 to 64.0 Msps makes some choices of Modulation
Type, FEC Coding and Data Rate selection invalid. Once the Tx Data Rate is edited, Press
.
ENTER
If Tx: Disabled is displayed, the port is turned Off (0 Mbps).
If Intfc1 Tx:
Intfc1 Tx Enable:
Enable
This selection activates or deactivates the transmit (Tx) side of this interface. Disabling the Tx
side deactivates it and changes the data rate to 0.
Select Enable or Disable using the
If Intfc1 Tx:
GBEI Tx Cable Alarm:
Alarm
This selection will affect the event reporting status upon detection of loss of GBEI Cable.
Select Alarm, Fault, or Mask using the
Tx
Enable Alarm (
Data is selected:
▲ ▼
Enable is selected:
Disable
◄ ►
Alarm is selected:
Fault Mask
E)
◄ ►
arrow keys. Press
(E)
(E)
arrow keys. The range of values is from 1.0 to 155.0
( E)
arrow keys. Press
ENTER
( E)
◄ ►
arrow keys. Press
6–39
MN/CDM700.IOM
.
ENTER
◄ ►
arrow keys. The value
.
.
ENTER
Revision 5