Table of Contents
Advertisement
CDM-700 High Speed Satellite Modem
Front Panel Operation
If Ethernet Config:
Ethernet IP Address/Range:
010.006.030.139/16 (
The operator uses this menu to set the modem's management IP address and subnet mask (range).
This is the address used by external applications to access and control the modem using the SNMP,
HTTP or Telnet interfaces. This also is the address used to upgrade the device firmware using FTP.
Edit the IP Address/Range address by selecting the digit to be edited, using the ◄ ► arrow keys.
The value of the digit is then changed using the ▲ ▼ arrow keys. Press
If Ethernet Config:
M&C Port MAC Address:
00-06-B0-00-47-12
This is a 'read only' status window that displays the factory program MAC address for the
Ethernet management interface. Press
Note: The preceding address is representative of a typical MAC address.
If Ethernet Config:
SNMP: Community
This is a 'read only' status window . Submenus enable setting of the destination IP address for
SNMP traps. Select Community or Traps using the ◄ ► arrow keys, then press
If SNMP
Community is selected:
SNMP Community:
Read
This menu is the entry point into setting the Read, Write, and Trap community strings used for
SNMP. Use the
to drop into the next level menu.
Address is selected:
MAC is selected:
ENTER
SNMP is selected:
Traps
(
E )
(
E )
arrow keys to toggle between Read, Write, and Trap, then press
▲ ▼
)
or
to return to the previous menu.
CLEAR
6–10
Revision 5
MN/CDM700.IOM
.
ENTER
.
ENTER
ENTER
Advertisement
Table of Contents
