Intfc1 (Cdi-10 Dual G.703 Interface); Intfc1: Alarm; Intfc1: Port1 - Comtech EF Data CDM-700 Installation And Operation Manual

CDM-700 High Speed Satellite Modem
Front Panel Operation

Intfc1 (CDI-10 Dual G.703 Interface)

CDI-10 Dual G.703 (E3/T3/STS1)
Intfc1 E3/T3/STS1: Alarm
Port1
Select Alarm, Port1, Port2 or Ext-Clk using the
There are two independent Tx/Rx port pairs on an CDI-10 G.703 Interface. There is common
reference, which may be used as a Rx Buffer reference clock for either port.
Intfc1: Alarm
Intfc1 Alarm/Fault:
Ext-Clk
To configure the loss of External Clock as either an Alarm or a Fault, Press
If Intfc1 Alarm/Fault:
Intfc# Ext-Clk Alarm/Fault:
Alarm
This selection will effect the reporting status if the event of loss of External Clock – and
subsequently, the switching logic – when the modem is in a 1:1 redundancy configuration.
Select Alarm, Fault, or Mask using the
Intfc1: Port1
Intfc1 Port1 E3/T3/STS1:
Type Line-Code Tx Rx (
Select Type, Line-Code, Tx, or Rx using the
If Intfc1 Port1 E3/T3/STS1:
Intfc1 Port1 Type: E3
STS1 34.368 Mbps
This menu allows port type selection for the interface. Select E3, T3, or STS1 using the
arrow keys. Press
Interface
Port2 Ext-Clk
Ext-Clk is selected:
Fault Mask (
Type is selected:
.
ENTER
Slot 1
Installed
◄ ►
arrow keys. Press
E)
◄ ►
arrow keys. Press
E)
◄ ►
arrow keys. Press
T3
( E)
6–23
MN/CDM700.IOM
Slot 2
CDI-10 Dual G.703 or None
.
ENTER
.
ENTER
.
ENTER
.
ENTER
Revision 5
◄ ►