Table of Contents
Advertisement
CDM-700 High Speed Satellite Modem
Front Panel Operation
This 'read-only' status window indicates if the modem is Resolved, Duplex, Speed, or Not
Resolved.
Status
Resolved -or-
Not Resolved
Duplex
Speed
6.3.5 (SELECT:) Save/Load
Save/Load Configuration:
Save
Note: When the unit is in Remote mode, any attempt to use this menu (i.e., by using the ◄ ►
arrow keys), displays the following message:
THIS UNIT IS CURRENTLY
IN REMOTE MODE!!
When in Local mode: Select Save or Load using the
and Load submenus permit storing or loading of up to 10 different modem configurations in the
non-volatile memory of the modem.
Save/Load Configuration:
Save Config to Loc: 9
Empty
Using Loc 9: as the example, if Save is selected and no configuration has been saved, the second
line reads 'Empty', as shown in the preceding example.
However, if the selected Loc: 9 already contains data, what displays is similar to the next example:
Save Config to Loc: 9
01:02:43
The time and date stamp of the previously stored configuration is displayed for identification
purposes.
Select the location to where the current configuration is to be stored, using the
then press
ENTER
Description
Displays whether Duplex and Speed has been Resolved or Not
Resolved.
Note: If GBEI Tx or Rx is Off, this is always blank.
This is only valid if Resolved.
This is only valid if Resolved.
10Mbps
100Mbps
1000 Mbps
Load
(
Save
05/08/05
(
. Locations 1 through 10 are available.
E)
arrow keys. Press
(
E)
E)
6–64
Revision 5
MN/CDM700.IOM
. The Save
ENTER
arrow keys,
Advertisement
Table of Contents
