Maintaining the printer
Cleaning the supply tracker
The supply tracker in the optional overlay or topcoat module can become
slippery, which might cause messages to appear. Clean the supply tracker weekly or
when needed.
Use a printer cleaning card to clean the supply tracker. You can also use a duplex/
laminator cleaning card; however, with this card, it is more difficult to clean the full
width of the supply tracker.
Clean the supply tracker
1
2
3
4
User's Guide for ImageCard® Magna™ and UltraGrafix® Magna™ Printers
Power off the printer.
!
The heated roller in the overlay or topcoat module operates at 400° F (200°
C). Wait 30 minutes or until the heated roller area is cool.
Lift the top cover, and then move the cover support down so it rests on the internal
frame.
If your printer has a locking cover, unlock the cover before opening it.
Prepare a printer cleaning card.
–
If you just used a printer cleaning card in the printer, you can use that card to
complete this procedure.
–
If you have not run a printer cleaning card, remove the protective paper from
one side of the card.
Figure 4-11: Remove the protective paper from the cleaning card
Lift the supply tracker until it stops and is held in place.
Remove the supply cartridge for easier access to the supply tracker. See
"Removing the supply cartridge" on page 2-8
for steps to follow.
4-11