144: Topping Foil Out; 147: Topping Foil No Tag Found; 150: Print While Unlocked; 172: Insert Cleaning Card - DataCard CE870 User Reference Manual

Datacard CE870 User Reference Guide

144: Topping foil out

Cause: The topping foil has run out.
1. Unlock and open the embosser.
2. Remove the topping foil cartridge.
3. Install new topping foil.
4. Replace the cartridge. Close and lock the embosser.
Refer to "Load the Topping Foil" on page 16 for more information.

147: Topping foil no tag found

Cause: The embosser cannot use the installed topping foil.
1. Unlock and open the embosser.
2. Remove the topping foil cartridge.
3. Install new topping foil.
4. Replace the cartridge. Close and lock the embosser.
Refer to "Load the Topping Foil" on page 16 for more information.

150: Print while unlocked

Cause: The printer is unlocked.
The card will be canceled.
Make sure that all access doors are closed and locked securely.
Refer to "Close the Printer Doors" on page 21 for more information.
8

172: Insert cleaning card

Cause: The printer is ready to be cleaned.
• If the cleaning card is in the input hopper, press the USER button.
OR
• If the cleaning card is not in the input hopper, insert the card into the printer
and then press the USER button.
Refer to "Clean the Printer" on page 10 for more information.

173: Improper shutdown

Cause: The system was shut down improperly or lost power.
1. Press and hold the USER button to clear the message.
2. Always use the POWER button to power off the printer.
Refer to "Check Power Connections" on page 22 and "Check Data Connections"
on page 23 for more information
Common LCD Messages
9