Verifying The Debower Position - DataCard ImageCard Magna User Manual

Using the printer
5
6
7
8

Verifying the debower position

The debower in the optional topcoat or overlay module should be set for the type of
cards you print. The debower assures that the heat used to apply the topcoat or
overlay does not leave cards bowed or curled.
Set the debower
!
1
User's Guide for ImageCard® Magna™ and UltraGrafix® Magna™ Printers
If the cartridge becomes stuck part of the way into the module, pull it out a few
inches and then turn the supply and take-up knobs clockwise
spindle ribs fit between the ribs. Push the cartridge in again.
Press the cartridge lock to secure the supply cartridge in the printer (step 2 in
Figure 2-12).
Lower the supply tracker until it rests on the supply material (step 3 in
Figure 2-12).
Verify that the cartridge is replaced correctly by making sure the locating posts
come through the locating holes in the cartridge
If needed, release the cartridge lock and seat the cartridge completely. Press the
cartridge lock again.
To close the cover, lift the top slightly. Move the support up so it is parallel with the
hinges and lower the cover.
If the printer has a locking cover, lock the cover after closing it.
Do not use the debower in the On position with proximity cards or smart cards.
Make sure power to the printer is off.
If the printer has a locking cover, unlock the cover before opening it.
Lift the top cover, and then move the support down so it rests on the internal
frame, as shown in Figure
!
The overlay or topcoat module is HOT to the touch and remains HOT for up to
30 minutes after the printer is powered off.
(Figure
2-5.
2-11
slightly so the
2-12).