Configuring Snmp Communities - NETGEAR ProSafe WG102-500 Reference Manual
802.11g wireless access point
Hide thumbs
Also See for ProSafe WG102-500:
- Installation manual (2 pages) ,
- Reference manual (52 pages)
Table of Contents
Advertisement
Figure 4-19
3.
Complete the basic SNMP fields and select the basic SNMP checkboxes as explained in
Table
4-9.
Table 4-9. SNMP Basic Settings
Field
Server Name
SNMPv1
SNMPv2
SNMPv3
SNMP Trap
SNMP Trap Receiver Name Enter the name of the device that should receive the traps that are sent
SNMP Trap IP Address
4.
Click Save or Save to Flash & Activate to save your settings.
Configuring SNMP Communities
To configure SNMP communities:
86 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Description
Assign a unique name to the SNMP server. The default name is
NETGEAR.
SNMP version 1 (SNMPv1) is supported by default. Deselect the Enable
checkbox to disable support for SNMPv1.
SNMP version 2 (SNMPv2) is supported by default. Deselect the Enable
checkbox to disable support for SNMPv2.
SNMP version 3 (SNMPv3) is supported by default. Deselect the Enable
checkbox to disable support for SNMPv3.
SNMP traps are enabled by default. Deselect the Enable checkbox to
disable SNMP traps.
from the wireless access point.
Enter the IP address of the device that should receive the traps that are
sent from the wireless access point.
Advertisement
Table of Contents
Troubleshooting
