Configuring Remote Management; Web Management Access; Configuring Web Management Access - NETGEAR ProSafe WG102-500 Reference Manual

To specify the number of neighboring APs that are shown in the table, use the pull-down
menu below the table and click the Refresh hyperlink.

Configuring Remote Management

You can remotely configure, upgrade, and check the status of your wireless access point by
using a variety of methods:
• Establish an Internet connection (either wired or wireless) to the wireless access point.
• Establish an L2TP management tunnel from a server to the wireless access point
• Establish a Telnet connection.
• Use the Simple Network Management Protocol (SNMP) in a network management
system.

Web Management Access

You can enable or disable the capability to log in to the wireless access point at its default
LAN address of http://192.168.0.229, using a wired or wireless connection. This capability is
enabled by default. If you disable the capability, you must use an SNMP or Telnet connection
to re-enable the capability, or reset the wireless access point to its factory default settings.

Configuring Web Management Access

To configure Web management:
1. Log in to the wireless access point at its default LAN address of http://192.168.0.229
with its default user name of admin and default password of password, or using
whatever LAN address, user name, and password you have chosen for the wireless
access point.
2. Select Configuration > WEB Administration > Web Access. The Web Access screen
displays (see Figure 4-14 on page
78 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
79).