Default Factory Settings - NETGEAR ProSafe WG102-500 Reference Manual

Specification
Maximum Computers Per
Wireless Network
Radio Data Rates
802.11b and g 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, and 54 Mbps
802.11b,g
Operating Frequencies and
Channels
802.11 Security

Default Factory Settings

When you first receive your wireless access point, the default factory settings are set as
shown below. You can restore these defaults with the Reset button on the rear panel (see
"Rear Panel" on page
Table 0-1.
Feature
User Name (case sensitive)
Password (case sensitive)
Operating Mode
Access Point Name
Built-in DHCP Server
IP Configuration
Network Name (SSID)
Broadcast Network Name (SSID)
WEP/WPA
MAC Access Control
Restricting connectivity based on MAC Access
Control List
Time Zone
122 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Description
Limited by the amount of wireless network traffic generated by each node.
Typically 20-30 nodes.
2.412 ~ 2.462 GHz (North America), Channels 1-11
2.412 ~ 2.472 GHz (Europe including France and Spain, and Japan),
Channels 1-13
40-bits (64-bit WEP), 104 bits (28-bit WEP), and 128-bits (152-bit WEP)
data encryption; WPA and WPA2
11).
Factory Default Settings
admin
password
Bridge
NETGEAR
DHCP server enabled, using the default IP address
IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
16 SSIDs: NETGEAR - 0, NETGEAR - 1, NETGEAR - 2,
and so on to NETGEAR - 15
Enabled
Disabled
Disabled
Disabled
Coordinated Universal Time (UTC)