•
Both wireless access points must use the same channel, authentication mode,
and security settings.
4.
Verify connectivity across LAN 1 and LAN 2.
A computer on either LAN segment should be able to connect to the Internet or
share files and printers of any other computers or servers connected to LAN
Segment 1 or LAN Segment 2.
Configuring Point to Multi-Point Bridge Mode
Set up a point to multi-point (P2MP) bridge only if the wireless access point (the
WGAP150) is the "master" for a group of bridge-mode wireless access points. Then
all traffic is sent to this "master," rather than to the other wireless access points. Up to
four profiles can be configured.
The following figure shows an example of a point to multi-point bridge mode
configuration.
Figure 5-8
106 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point