Disabling Web Management Access Entirely - NETGEAR ProSafe WG102-500 Reference Manual

WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Figure 4-15
3. Next to Management from Wireless Clients, the Enabled checkbox is selected by default. To
disable Web management from wireless clients, deselect the Enabled checkbox.
WARNING!
If you access the wireless access point from a wireless client and
you disable management from wireless clients, you will lose your
Web management access when you click Save to Flash and
Activate. You must then access the Web management interface
from a client over a wired connection.
4. Click Save or Save to Flash & Activate to save your settings

Disabling Web Management Access Entirely

Disabling Web management access entirely prevents both wired and wireless clients to log in
to the wireless access point at its default LAN address of http://192.168.0.229.
WARNING!
If you disable Web management access entirely, you will lose your
Web management access when you click Save to Flash and
Activate. You must then use an SNMP or Telnet connection to
re-enable Web management access, or push the Reset button to
reset the wireless access point to its factory default settings.
| 81