Configuring Telnet Server Access - NETGEAR ProSafe WG102-500 Reference Manual

5. Click Save or Save to Flash & Activate to save your settings.

Configuring Telnet Server Access

You can allow a remote host to establish a Telnet connection to the wireless access point
over the LAN port. The following Telnet commands are supported on the wireless access
point:
Set SSID (sets the SSID)
Set Channel (sets the channel)
Set Radio Mode (sets the radio mode to b, b/g, or g-only)
Set Data Rate (sets the data rate to auto or fixed)
Get Firmware Version (shows the firmware version)
Get Serial Number (shows the serial number)
Get Lan MAC Address (shows the LAN MAC address)
Get Wi-Fi MAC Address (shows the wireless interface MAC address)
Apply Config (Restart Connection) (re-applies the configuration)
Clear Config (clears the configuration)
Reboot (reboots the unit)
To allow Telnet access from a remote host:
1. Log in to the wireless access point at its default LAN address of http://192.168.0.229
with its default user name of admin and default password of password, or using
whatever LAN address, user name, and password you have chosen for the wireless
access point.
2. Select Configuration > System > Security. The Security screen displays (see
on page 85).
84 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Figure 4-18