Snmp Remote Management; Configuring Snmp Settings - NETGEAR ProSafe WG102-500 Reference Manual
802.11g wireless access point
Hide thumbs
Also See for ProSafe WG102-500:
- Installation manual (2 pages) ,
- Reference manual (52 pages)
Table of Contents
Advertisement
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Figure 4-18
3.
Next to Telnet Server, select the Enabled checkbox. This checkbox is deselected by default.
4.
Click Save or Save to Flash & Activate to save your settings.
SNMP Remote Management
SNMP forms part of the internet protocol suite as defined by the Internet Engineering Task
Force (IETF). SNMP is used in network management systems to monitor network-attached
devices for conditions that warrant administrative attention.
SNMP exposes management data in the form of variables on the managed systems, which
describe the system configuration. These variables can then be queried (and sometimes set)
by managing applications
Enable SNMP to allow SNMP network management software such as HP OpenView to
manage the wireless access point via the SNMPv1, SNMPv2, and/or SNMPv3 protocol.
Configuring SNMP Settings
To configure and enable SNMP:
1.
Log in to the wireless access point at its default LAN address of http://192.168.0.229
with its default user name of admin and default password of password, or using
whatever LAN address, user name, and password you have chosen for the wireless
access point.
2.
Select Configuration > SNMP > Basic. The SNMP Basic Settings screen displays (see
Figure 4-19 on page
86).
| 85
Advertisement
Table of Contents
Troubleshooting
