Scheduling To Activate The Changes; Rebooting Without Restoring The Default Configuration - NETGEAR ProSafe WG102-500 Reference Manual

Scheduling to Activate the Changes

This procedure lets you schedule the activation of any configuration changes, so that
changes can be activated at a time when a minimum number of users are impacted.
However, this procedure does not save the changes to flash memory, so the changes are lost
when you reload the wireless access point.
To schedule the activation of changes:
1. On the Configuration screen (see
below Activate Changes, enter the time in seconds that the activation should be
delayed. The default is zero seconds, which means that there is no delay and the
changes are activated immediately.
2. Below Activate Changes, click Proceed. If your browser requires a confirmation to proceed,
confirm the action.

Rebooting without Restoring the Default Configuration

You can reboot the wireless access point without restoring the default configuration by using
the software reboot button on the Miscellaneous screen:
1. Log in to the wireless access point at its default LAN address of http://192.168.0.229
with its default user name of admin and default password of password, or using
whatever LAN address, user name, and password you have chosen for the wireless
access point.
2. Select Maintenance >Misc. The Miscellaneous screen displays. This screen also lets you
download debug information (see
displays the current firmware version.
Figure 4-2
3. Next to Reboot, select the flash memory to reboot from and click Proceed. If your browser
requires a confirmation to proceed, confirm the action. A few seconds later, only the power
64 |
WG102-500, WGAP150 ProSafe™ 802.11g Wireless Access Point
Figure 4-1 on page
"Downloading Debug Information" on page
62), in the Delay Options field
119) and