This chapter describes how to use the management features of your NETGEAR ProSafe 802.11g
Wireless Access Point WG302. To get to these features, connect to the WG302 as described in
"Logging in to the WG302 Using Its Default IP Address" on page
Remote Management
Access the Remote Management screen by clicking Remote Management under Management on
the main menu.
Figure 4-1
Enter the Remote Management information.
•
Remote Console, Secure Shell (SSH): If set to Enable, the Wireless Access Point will only
allow remote access via Secure Shell and Secure Telnet. The default is Enable.
•
SNMP: Enable SNMP to allow the SNMP network management software, such as HP
OpenView, to manage the wireless access point via SNMPv1/v2 protocol.
Management
v0.1, December 2005
Chapter 4
Management
3-9.
4-1