ProSafe Wireless-N Access Point WNAP320 Reference Manual
Remote Management
Both the SNMP and Remote Console are enabled by default, which allows for remote
management of the WNAP320 from a client running SNMP management software, as well as
from a secure Telnet console.
To set up an SNMP management interface:
Select Maintenance > Remote Management > SNMP. The SNMP screen displays, as
1.
shown in
Figure 1,
Figure 1.
Enter the following information in the SNMP fields:
2.
SNMP. Enable SNMP to allow the SNMP network management software, such as HP
•
OpenView, to manage the wireless access point through SNMPv1/v2 protocol.
Read-Only Community Name. The community string to allow the SNMP manager to
•
read the wireless access point´s MIB objects. The default is Public.
Read-Write Community Name. The community string to allow the SNMP manager
•
to read and write the wireless access point´s MIB objects. The default is Private.
Trap Community Name. The community string to allow the SNMP manager to send
•
traps. The default is Trap.
IP Address to Receive Traps. The IP address of the SNMP manager to receive
•
traps sent from the wireless access point. The default is 0.0.0.0.
Click Apply.
3.
.
Chapter 3. Management
| 21