Navigational Aid For Cli Commands - Avaya G700 Installation And Upgrades

Navigational Aid for CLI Commands

This section describes a few Command Line Interface commands that you will need to navigate between the
processors on the G700.
Log in to the P330 stack processor. Default mode is "Supervisor" with a P330-1(super)# command-line
prompt.
Command
super
configure
session <module #> mgp
(from a stack processor session)
session <module #> stack
(from an MGP session)
session icc
(from an MGP session)
session <#>
exit
<command>
The command-line prompts in an MGP session use the media gateway's name that is assigned when it is
configured.
You can telnet to another processor from a current telnet session.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
1 Roadmap and Reference: Navigational Aid for CLI Commands
change to supervisor
change to configura-
open a CLI session on
the mgp processor
open a CLI session on
the stack processor
open a CLI session on
the S8300 processor
open a session on the
stack processor in
module (i.e. another
G700)<#> in the stack
close the current ses-
sion (and revert to the
previous session)
displays help for <com-
help
Purpose
mode
tion mode or <MG name>-1(configure)#
mand>
Prompt
P330-1(super)#
or <MG name>-1(super)#
P330-1(configure)#
<MG name>-1(super)#
P330-1(super)#
craft@<host name>>
P330-<#>(super)#
59