Administer Network Regions - Avaya G700 Installation And Upgrades

3 Installing a New G700 with an S8300: Administer Communication Manager
2. Go to page 2
Example Node Names Screen.
change node-names ip
Name
default_________
node-10-lsp
node-11-lsp
__________
__________
__________
3. Enter the name and IP addresses for the LSPs.
Press (
4. F 3

Administer Network Regions

Before assigning an IP network region to a G700, you must define network region on the IP Network
Region form. After a network region is defined, you can assign it to the various network elements
(servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use the
system defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region, defined as
1 . The procedure below uses 1 for the network region number as an example but the procedure
applies for any network region number from 1 to 250.
Define IP network region 1
!
CAUTION:
Defining IP network regions can be quite complex. For detailed information on the use and
administration of IP network regions, see ''Administration for Network Connectivity for
Avaya™ Communication Manager, 555-233-504.''
1. At the SAT prompt, type change ip-network-region 1.
The S8300 displays the IP Network Region screen.
140
IP Address
0__.0__.0__.0__
192.168.1 _.50_
192.168.1 _.51_
___.___.___.
___.___.___.
___.___.___.
) when complete.
E NT ER
Installation and Upgrades for G700 with S8300 or S8700
NODE NAMES
Name
_______________
_______________
_______________
_ _______________
_ _______________
_ _______________
555-234-100 — Issue 3 — May 2003
Page 2 of 2
IP Address
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___
___.___.___.___