Avaya G700 Installation And Upgrades page 125

Assign the IP address to the P330 stack processor
At the P330-1(configure)# prompt, type
1.
set interface inband <vlan> <ip_address> <netmask> to assign an IP
address to the P330 stack processor.<vlan> is the vlan number, usually 1, to be established on
the S8300 for the G700 Media Gateways. The <ip_address> <netmask> is the assigned
addresses for the P330 stack processor.
Type reset and press
2.
3. Select Yes
All LEDs will flash. As the unit powers up, self-tests will be run. When the G700 mpg or P330
stack processor has reset, login again to continue.
4. Login at the
The prompt P330-1(super)# appears.
5. Type configure to obtain the P330-1(configure)# prompt.
Establish the IP Routing for the Stack
Type show interface inband to verify that the Avaya P330 stack server (Layer 2
1.
Switching Processor) has the correct address.
Type set ip route 0.0.0.0 <default-gateway> to set the destination and gateway
2.
IP addresses. You will find these addresses in the planning documentation.
<default-gateway> is the IP address of the customer's network gateway.
Press
3. Enter
4. Type show ip route.
The route net and route host tables appear. Verify that the information is correct.
Check the serial number of the G700 Media Gateway processor
After you have configured the P330 stack processor, you will assign an IP address to the G700
Media Gateway Processor (MGP). Your first step is to check the serial number of the MGP.
1. At the P330-1(configure)# prompt, type session mgp.
At the MG-???-1(super)# prompt, type show system to list various attributes of the
2.
G700.
The system displays a list of attributes, as shown in the following example:
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
3 Installing a New G700 with an S8300: Configure the G700 Media Gateway
to reset the stack.
Enter
at the dialog box that asks if you want to continue.
Welcome to P330 menu.
to save the destination and gateway IP addresses.
125