Navigational Aid For Cli Commands - Avaya G700 Installation And Upgrades

1
Roadmap and Reference

Navigational Aid for CLI Commands

Navigational Aid for CLI Commands
This section describes a few Command Line Interface commands that you will need to navigate between
the processors on the G700.
Log in to the P330 stack processor. Default mode is "Supervisor" with a P330-1(super)# command-line
prompt.
Command
super
configure
session <module #> mgp
(from a stack processor session)
session <module #> stack
(from an MGP session)
session icc
(from an MGP session)
session <#>
exit
<command> help
The command-line prompts in an MGP session use the media gateway's name that is assigned when it is
configured.
You can telnet to another processor from a current telnet session.
66
Purpose
change to supervisor mode
change to configuration
mode
open a CLI session on the
mgp processor
open a CLI session on the
stack processor
open a CLI session on the
S8300 processor
open a session on the stack
processor in module (i.e.
another G700)<#> in the
stack
close the current session
(and revert to the previous
session)
displays help for
<command>
Installation and Upgrades for G700 and S8300
Prompt
P330-y(super)#
or
<MG-xxx>-y(super)#
is the media gateway number
where xxx
assigned on the "add media-gateway" form,
and is the "module number" of the G700 in
y
the stack.
P330-1(configure)#
or
<MG-001>-1(configure)#
<MG-001>-1(super)#
P330-1(super)#
<host name>
craft@ >
P330-<#>(super)#
December 2003