Avaya G700 Installation And Upgrades page 260

7 Connecting Telephones and Adjunct Systems: Installation and Wiring Telephones and Power Supplies
Connect the 1152A1 PDU
!
CAUTION:
The 1152A1 PDU has no ON/OFF switch. To connect or disconnect power to the
1152A1 PDU, simply insert or remove the power cable from the AC power receptacle on the
rear of the 1152A1 PDU.
Plug a power cord into the power socket on the rear of the 1152A1 Power Distribution Unit.
1.
2. Plug the other end of the power cord into the power receptacle.
The 1152A1 PDU powers up, and the internal fans begin operating.
The 1152A1 PDU then runs through its Power On Self Test (POST), which takes less than
10 seconds. During the test, all the ports on the unit are disabled and the LEDs light up. For more
information on the test, refer to the user's guide that comes with the unit.
Connect the Cables
All of the ports on the front of the 1152A1 PDU are configured as data route-through ports for all data
wires (pins 1, 2, 3 and 6).
1 2 3 4 5 6
Data &
Power
Data
Use a standard CAT5, CAT6 or CAT6e straight-through Ethernet cable (not supplied), including all 8
wires (4 pairs) as shown in
Figure 17. Connecting telephones and other end devices to the 1152A1 PDU
Ethernet
Switch/Hub
1
2
3
4
5
6
7
8
For Data-In ports connect the Ethernet cable leading from the Ethernet Switch/Hub to the Data port.
For Data & Power Out ports connect the Ethernet cable leading to the telephone or other end device
to the corresponding Data & Power port.
Note: Be certain to connect correspondingly numbered Data and Data & Power ports.
260
7 8 9 10 11 12 13
"Connecting cables to telephones and other end devices" on page
1152A1 Power Distribution Unit
RJ-45 IN
data
1
data
2
data
3
spare
4
spare
5
data
6
spare
7
spare
8
Installation and Upgrades for G700 with S8300 or S8700
14 15 16 17 18 19 20
RJ-45 OUT
data
1
data
2
data
3
DC +
4
DC +
5
data
6
DC -
7
DC -
8
555-234-100 — Issue 3 — May 2003
21 22 23 24
1152A1 Power
Distribution Unit
AC
Console
48Vdc
261.
End Device
1
2
3
4
5
6
7
8