Configure The G700; Assign The Ip Addresses Of The G700 Media Gateway Components - Avaya G700 Installation And Upgrades

Media gateway controlled by media server
Hide thumbs Also See for G700:
Table of Contents

Advertisement

4 Installing a New G700 without an S8300: Configure the G700

Configure the G700

Note: If you are using the Avaya Gateway Installation Wizard (GIW), the GIW performs
tasks automatically in the
Components
Connections
configure an X330 Expansion module. This task you must still perform as
described in this document.
For a new installation of a G700 Media Gateway, you must complete the following configuration tasks:
• Assign IP addresses to the G700 processors
• Assign IP routes for the gateway
• Set up the controller list
Assign the IP Addresses of the G700 Media
Gateway Components
Note: If you are using the Avaya Gateway Installation Wizard (GIW), the GIW performs
this task automatically.
This section describes how to assign the IP addresses and IP routes to the G700 Media Gateway and
its components. The IP addresses should be available to you on the IP Addressing Planning Form.
The command arguments you will be supplying include:
vlan
IP address
netmask
destination
default gateway
168
Assign the IP Addresses of the G700 Media Gateway
,
Set up the Controller List for the G700 Media Gateway
, and
Set the LSP Transition Points
–Virtual Local Area Network: a defined network segment that
allows users on that segment to have priority services in sharing
information with each other.
If the network is not using VLANs, the VLAN should be 1.
Otherwise, use the VLAN numbers indicated in your planning
forms. The G700 Media Gateway should be assigned the same
VLAN as the VLAN to which the Ethernet ports are connected. The
P330 stack processor might or might not be assigned to the
customer's network management VLAN.
–the unique identifier assigned to an entity on the customer LAN
–the subnet mask for the customer's LAN segment
–distant networks that the IP route command needs to send
packets to. Usually generalized to 0.0.0.0 for networks other than
the local segment.
–the gateway the ip route command specifies to get to the distant
networks
Installation and Upgrades for G700 with S8300 or S8700
,
Check for IP
sections. However, the GIW does not
555-234-100 — Issue 3 — May 2003

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8300S8700

Table of Contents