If The Target S8300 Is The Primary Controller - Avaya G700 Installation And Upgrades

Run Save Translations (Only If New License and/or Authentication Files Installed)
!
CAUTION:
This procedure saves the official passwords for the customer's system. If you fail to perform
this step now, you may be irretrievably locked out of the system later in the installation when
the system reboots.
In the telnet session, open a SAT session.
1.
Log in again as craft.
2.
At the SAT prompt, type
3.
When the save is finished, the system displays the message, Command successfully
completed.

If the Target S8300 is the Primary Controller

Skip this section if the S8300 is configured as an LSP.
Perform the following procedures if you are upgrading an S8300 that is configured as a primary controller.
Clear Alarms
On the S8300 main menu under Alarms and Notification, click
1.
Select the alarms to be cleared and click
2.
Resolve any major alarms through the Communication Manager SAT.
3.
Back up the System
Make sure you have the IP address of the customer's FTP backup server.
1.
2. On the S8300 main menu, select
The system displays the Backup Now screen.
Select the type of data you want to back up by selecting the appropriate data set.
3.
Normally, you should select all of the options:
- Avaya Call Processing (ACP) Translations
• Save ACP translations prior to backup
- Server and System files
- Security Files
Note: The Security files contain the authentication (password) file, but not the license
file. So the license file will not be backed up.
Select a backup method, normally FTP, to indicate the destination to which the system sends the
4.
backup data.
Complete the following fields:
5.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
5 Upgrading an Existing G700 with an S8300: On site Preparation for the Upgrade
save translations
Backup Now
and press .
Enter
View Current Alarms
.
Clear
.
.
215