Administer The Lsp Form - Avaya G700 Installation And Upgrades

4 Installing a New G700 without an S8300: Administer Communication Manager

Administer the LSP Form

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable the
LSPs to get translations updates from the primary controller. Once the LSPs are successfully entered
on the LSP form, their status can be viewed with the display lsp command.
Note: The LSP node names must be administered on the node-names-ip form before
they can be entered on the LSP form.
Add LSP names to the LSP form
1. At the SAT prompt, type change lsp to open the LSP form.
LSP Screen
change lsp
Number NAME
1 node-10-LSP__ 192.168.1.51
2 ____________
3 ____________
4 ____________
5 ____________
6 ____________
7 ____________
8 ____________
9 ____________
10 ____________
11 ____________
12 ____________
13 ____________
14 ____________
15 ____________
16 ____________
Enter the node name for each LSP supported by the primary controller and submit the form.
2.
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT session.
!
CAUTION:
Before administering a media gateway, make sure that the gateway has been fully
configured.
Add Media Gateway
At the SAT prompt, type add media-gateway <number>
1.
where <number> is the gateway number from 1 to n . (n is 50 for an S8300 and 250 for an
S8700).
202
LOCAL SURVIVABLE PROCESSOR
IP Address
Installation and Upgrades for G700 with S8300 or S8700
Page
Currently Translations
Available? Updated
y 13:06 5/4/2003
n
n
n
n
n
n
n
n
n
n
n
n
n
n
n
555-234-100 — Issue 3 — May 2003
1 of 16