Avaya G700 Installation And Upgrades page 126

3 Installing a New G700 with an S8300: Configure the G700 Media Gateway
Show System List for G700 Media Gateway
MG-001-1(super)# show sys
Uptime(d,h:m:s): 1, 08:17:12
System Name
System Location: -- Empty --
System Contact : -- Empty --
MAC Address
Serial No
Model No
HW Vintage
HW Suffix
FW Vintage
Media Gateway Power Supplies
DSP Complex
MGP
Fans
Media Modules
VoIP DSP
VoIP 8260
Aux
--type q to quit or space key to continue--
MG-???-1(super)#
Write the serial number on your planning document. Make sure it matches the serial number
3.
sticker on the back of the G700 Media Gateway chassis. If there is a difference, the serial number
in the displayed list is correct.You will need this later.
Assign the IP Address to the G700 Media Gateway Processor
If, after you have assigned an IP address to the G700 processor, you telnet directly to the G700
Media Gateway processor, you will need to login, and the login name and password will be
provided in the planning documentation.
1. At the MG-???-n(super)# prompt, type configure to change to configuration mode.
Type nvram init to recondition the processor. (This command ensures that any existing
2.
configuration information is cleared so you can enter the IP address and IP route information).
The system prompts you to verify that you want to erase the configuration.
Answer the prompt by typing y(es).
3.
This procedure re initializes the G700 software back to factory defaults so new IP addresses can
be stored correctly in the software. It also clears all configuration and administration on the G700
Media Gateway.
The G700 Media Gateway re initializes.
4. At the P330-1(configure)# prompt, type session mgp.
At the MG-???-1(super)# prompt, type configure to change to configuration mode.
5.
126
: -- Empty --
: 00-04-0D-02-04-EF
: 02DR07428721
: G700
: 00
: A
: 230
VOLTAGE(V) ACTUAL(V)
---------- ---------- ----------
3.4 3.359
5.1 5.000
1.2 0.000
-48.0 -47.259
1.6 1.570
2.5 2.470
-48.0 0.000
Installation and Upgrades for G700 with S8300 or S8700
STATUS
OK
OK
OK
OK
OK
OK
OK
555-234-100 — Issue 3 — May 2003