Disassembly And Assembly Of Clutch Control Arm, Clutch; Release Shaft Oil Seal, And Clutch Release Bearing; Disassembly; Assembly - Chery automobile Service Manual

DISASSEMBLY AND ASSEMBLY OF CLUTCH CONTROL ARM, CLUTCH

RELEASE SHAFT OIL SEAL, AND CLUTCH RELEASE BEARING

Disassembly:

Drive car to the platform.
Disassemble the clutch control cable

assembly.

Disassemble engine bracket on the
transmission side.
Lift the vehicle by lifter.
Discharge all the transmission oil by screw
off the drain bolt under the differential.
Get off the back cover by punch, do not hurt
the contact surface. Disassemble the fixing
clip of the separated finger; pull off clutch
release shaft, separated finger and spring.
Take off clutch release bearing, and punch off
clutch release shaft oil seal assembly. Do not
hurt the contact surface.
Assembly:
Assembly is opposite to the disassembly process,
pay attention to the following items:
Lubricate the oil seal surface and put it in by a
special tool.
Assemble clutch separated finger to the
position shows in the picture, and then
assemble release bearing, spring and clip. The
spring position shows in the picture.
Press the new back cover to its right position
by special tool. If it is assembled on the
vehicle, extra work as below: fill transmission
oil to the specified level.
Lower the vehicle on the platform and
connect to clutch control cable.
J-28