To Change Vertical Sensitivity - Agilent Technologies U1602B User's And Service Manual

3 Using the Scope Functions

To Change Vertical Sensitivity

By pressing the
(Volts/div) of a waveform. The vertical scale factor changes the Volts/div
scale in a 1- 2- 5 step sequence depending on the probe attenuation.
• 5 mV/div to 100 V/div for 1:1 scope probe
• 50 mV/div to 1 kV/div for 10:1 scope probe
• 500 mV/div to 10 kV/div for 100:1 scope probe
To change vertical sensitivity for each channel, use the
factor button for sensitivity increment and reduction. Press the upper
button (with mV indicator) to increase vertical sensitivity or press the
bottom button (with V indicator) to reduce it. The channel Volts/div value
is displayed in the status line (refer to
23") as shown in Figure 3- 5.
Figure 3-5 Vertical sensitivity display
By pressing the
N O T E
menu will appear.
30
button, you can change the vertical sensitivity
Vertical sensitivity
button for channel 1 or channel 2, the respective channel's setting
Agilent U1602B/U1604B User's and Service Guide
"Oscilloscope Display Overview
vertical scale