Agilent Technologies U1602B User's And Service Manual page 201

1 Remove two screws at the location shown in Figure 8- 3 and open up
Figure 8-5 Remove battery pack cover without removing stand
2 Use tweezer to unplug the battery pin connector gently through the
Figure 8-6 Unplug 2-wire connector with a tweezer.
3 Install a new battery pack and proceed to reassemble the battery pack
162
the battery cover.
stand hole as shown in Figure 8- 6.
in reverse instructions.
Agilent U1602B/U1604B User's and Service Guide
General Disassemble 8