Figure 12-3. Trunk Configuration, General tab
Selecting Trunks to Set Attributes
The title bar of the Trunk Configuration window displays the card and the channel of the
selected trunk.
The list on the left shows all the configured trunks. The Location format is the same as
in the Trunk View window, that is, Logical Component ID : Channel number. The logical
component ID is assigned by the system. This ID may change when a component is
added into or removed from the system.
When you select a trunk in this list, the options and parameters for the trunk appear in
the settings in the right side of the window.
Configuring One or Multiple Trunks
To customize trunk characteristics, you work on one trunk at a time. To apply the same
configuration to multiple trunks, use the Apply To button. This pops up a list of all
trunks, with all of the trunks selected by default. Select the trunks you want to apply
changes to, then click OK. (Use Ctrl+click and Shift+click to select several trunks.) This
applies changes to multiple trunks for only the attribute or option that you changed.
Selecting Trunks to Set Attributes
MaxACD Administrator Manual 99