Cabinet; Addition And Deletion Of Rack-Mountable Dual Power Feed - Fujitsu SPARC Enterprise M8000 Service Manual

24
C H A PT E R
Addition and Deletion of a RDPF
Option, Power Cabinet, and M9000
Expansion Cabinet
This chapter explains the procedures for adding and deleting a rack-mountable dual power
feed option (RDPF), a power cabinet, and an M9000 expansion cabinet, all of which are
server options. In the chapter, deletion of such an option means that the work of removing it
involves moving the server.
These options are not FRUs. Normally, the system configuration has been determined prior
to shipment, so the options are not intended to be added or deleted by a user or field
engineer. However, if the system configuration is changed or the system is transported to
another location, addition or deletion of one of the options may be required. The sections
below explain the following:
Section 24.1, "Addition and Deletion of Rack-mountable Dual Power Feed" on page 24-1
■
Section 24.2, "Addition and Deletion of Power Cabinet" on page 24-13
■
Section 24.3, "Addition and Deletion of M9000 Expansion Cabinet" on page 24-16
■
For the basic installation procedures, see the SPARC Enterprise M8000/M9000 Servers
Installation Guide. No section in the SPARC Enterprise M8000/M9000 Servers Installation
Guide explains this addition and deletion work. Interpret an installation procedure as an
addition procedure and a removal procedure as a deletion procedure.
24.1 Addition and Deletion of Rack-mountable
Dual Power Feed
This section explains the procedure for replacing a rack-mountable dual power feed unit
(RDPF). The sections below explain the following:
24-1