Fujitsu SPARC Enterprise M8000 Service Manual page 451

Mounting the Connector Unit (Rear of M8000)
FIGURE 24-5
o. Mount the two brackets (with two screws each) for securing the ACS on the side
panel at the rear of the equipment rack of the M8000 server. For their mounting
locations, use the second and third holes from the bottom, and secure them.
p. From the rear of the server, mount the ACS mounting frame, and secure it at the
rear of the server (with three screws each on both sides). Secure the two brackets
for securing the ACS (one screw each) and the dual power feed unit at the rear of
the server (with three screws on each side).
q. Secure the ACS mounting frame and the two brackets mounted in
screws (one screw each).
Chapter 24 Addition and Deletion of a RDPF Option, Power Cabinet, and M9000 Expansion Cabinet
Step o with
24-9