Active Replacement - Fujitsu SPARC Enterprise M8000 Service Manual

TABLE 13-1
TABLE 13-1
Slot Name
PCI slot
For the following devices, replacement procedures have the same steps except that LEDs to
be checked, eject levers, and names used for status display are different.
PCI cassette (PCICS)
■
PCI card
■
IOU onboard device card (IOUA)
■
Link card
■
Note – The steps of the replacement procedures for I/O boxes and link cards mounted in
external I/O expansion units, PCI cards, I/O boards, and power supply units are basically the
same as those described in this manual. For details, see the External I/O Expansion Unit
Installation and Service Manual.
The following explains the replacement procedure for a PCI card, which is a typical example.
13.2

Active Replacement

The PHP function enables active replacement of PCI cassettes (PCICSs) and link card.
Active replacement cannot be performed for IOU onboard device cards (IOUAs).
The active replacement procedure is as follows.
1. Unlock and open a door of the server. (See
Caution – Before touching a FRU or dummy (filler) unit, see
Precautions" on page 1-9
result in serious damage to operating domains.
13-4 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
shows abbreviated name and numbers of PCI slots in an IOU.
Abbreviated Name and Numbers of PCI Slots
and be sure to wear the antistatic wrist strap. Failure to do so might
Abbreviated Name and Numbers
PCI#0 to 7
Chapter 5)
Section 1.4, "Antistatic