Fujitsu SPARC Enterprise M8000 Service Manual page 454

Mounting the PSU (Front of the M8000)
FIGURE 24-8
10. Connect power cords to the added rack-mountable dual power feed unit.
11. Switch on all main line switches for AC section (ACS) of both power supply systems.
12. Confirm that the XSCF STANDBY LED (green) on the operator panel remains lit.
If it is blinking, wait until it remains lit.
13. Use one of the following methods to start (power on) all domains at once.
■
24-12 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
Press and hold down (for less than four seconds) the POWER switch on the operator
panel.
screws