13. Use one of the following methods to start (power on) all domains at once.
Press and hold down (for less than four seconds) the POWER switch on the operator
■
panel.
From a console that is connected to XSCF, execute the poweron -a command of
■
XSCF.
The power to all the domains is turned on, and then the power-on self test (POST) is
executed. When ok prompt displayed on the console of relevant domain, POST is
completed.
For details of the power-on operation, see
page
4-22, and the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers XSCF
User's Guide.
14. Restore the original mode switch setting on the operator panel.
Note – When the maintenance work is completed, be sure to confirm the mode switch
setting and return the switch to Locked.
15. Close the door on the server, and lock it.
Section 4.4.2, "Powering the Server On" on
Chapter 21
Sensor Unit Replacement
21-9