Tools Required For Maintenance - Fujitsu SPARC Enterprise M8000 Service Manual

1.3

Tools Required for Maintenance

The maintenance work described in
to confirm that the server and other components are operating correctly and to collect status
information and log data about the server and components. The work for mounting,
removing, or replacing a specific component requires screwdrivers, and special tools such as
an antistatic wrist strap. These items are listed in
Maintenance Tools
TABLE 1-1
No. Name
1 Torque wrench
[8.24 N•m (84 kgf•cm)]
2 Sockets for 10 mm (M6) torque
wrench
3 Sockets for 13 mm (M8) torque
wrench
4 Torque wrench extension
5 Torque screwdriver
[0.2 N•m (2.0 kgf•cm)]
6 Slotted bit
7 Wrist strap
8 Antistatic mat
9 CPU module replacement tool
10 Oracle VTS
Caution – Before handling the components, be sure to connect the clip of the antistatic
wrist strap and the antistatic mat to the server grounding port, and attach the band of the
wrist strap to one of your wrists. Place the component on the grounded antistatic mat with
your hand wearing the antistatic wrist strap, to eliminate static electricity in advance of
installation. Failure to take these antistatic measures might result in serious damage.
1-8 SPARC Enterprise M8000/M9000 Servers Service Manual • October 2012
Chapter 6 to Chapter 24
TABLE 1-1
Use
Used to secure the bus bars of the power cabinet.
Used to replace the backplane (BP_A) in the M8000 server.
Used to secure the bus bars of the power cabinet.
Used to secure the clock cables between the cabinets if the expansion
cabinet of the M9000 server is installed.
Used to secure the clock cables between the cabinets if the expansion
cabinet of the M9000 server is installed.
For antistatic purposes
For antistatic purposes
For mounting and removing CPU Modules (accessory)
Test program
requires maintenance software
.